...
...
In PI Vision oben links auf “Assets” klicken um entsprechenden Bereich aufzuklappen.
Im oberen Bereich mit einem Klick auf “weruGauge” das Control selektieren.
Im Anschluss kann das gewünschte Attribut nach Navigation durch den Asset Tree per Drag&Drop dem Display hinzugefügt werden. Der Tacho erscheint und zeigt den Wert des ausgewählten Attributs zum in PI Vision angegebenen Endzeitpunkt an (unten rechts).
Konfigurationsmöglichkeiten
Mit einem Rechtsklick auf das Control besteht die Möglichkeit auf “Konfigurieren” zu drücken. Dadurch erscheint die Konfigurationskachel.
...
Dort kann der maximale Wert des Tachos konfiguriert werden.
Entfernen des Controls
Als erstes muss in den Bearbeitungsmodus gewechselt werden (Icon oben rechts).
...
Starting the Control
To start the control click on the “Assets” button in the upper left corner of the PI Vision display.
In the upper part select “weruGauge” by clicking on it.
Afterwards the desired attribute from the asset tree could be added to the display via drag and drop. The Gauge control appears on the display and can be used.
Configuration
With a right click on the control in the upper area there is the possibility to press "Configure". Thereby the configuration tile appears.
...
There you can configure the maximum value of the gauge.
Removing the Control
Before removing the control it is necessary to switch into edit mode (Icon in the upper right corner). Thereafter it is possible to click on the control and press the delete key to remove the control.